Skip to Main Content Skip to Footer Content

Agmate® Finishing Mower, 6' Rear Discharge, 6FMOWR

Item #65059
The average rating for this product is 5 out of 5 stars
24 reviews
This Agmate® finishing mower is ideal for large lawns or golf courses. The 6 ft. 3-point mower has a 71.65 in. cutting width with a 42 in. rear discharge to make cutting your lawn easier.
Due to product size and/or weight, this product ships via Motor Freight Truck only. Liftgate service may not be available. Please be prepared to remove large items from the truck.
Availability:
Product Overview

This Agmate® 6 foot finishing mower will allow close mowing to shrubs and buildings for faster yard maintenance. Either side may be used for close trimming, which is a feature that is not available on side discharge systems. The rear discharge gives you an advantage for eliminating grass buildup in uncut areas; it also reduces blade wear and fuel costs.


The high lift blades lift the grass and cut it cleanly. It then discharges the cut grass neatly to the rear of the mower path. The 42 inch discharge throat provides an almost unobstructed flow of cut material and the chain guard allows the grass to be safely and smoothly discharged.


This 3-point mower has 4 caster gauge wheels that adjust the cutting height and allow the deck to float with the ground contour. The solid rubber flotation tires are not affected by punctures or tire pressure loss, ensuring an even cut every time.


The finishing mower has 3 belt driven blades with a chain guard. The mower has category 1 hitch pins installed, and a quick coupler PTO driveline shaft is included. The recommended tractor HP for this mower is 22 to 50.


    Specifications:
  • Agmate┬« EM6
  • 6 foot finishing mower
  • PTO drive: 540 RPM
  • Recommended tractor horsepower: 22 to 50
  • Overall width: 72.44"
  • Measurement from front to rear: (outside of wheel to outside of wheel) 59"
  • Cutting width: 71.65"
  • Cutting height: 1.38" - 4.53"
  • Weight: 546 lbs.
  • Number of blades: 3
  • Deck thickness: 9.5 gauge (3.5 mm)
  • Gearbox HP: 45
  • PTO driveline: series 4
  • Blade thickness: 1/4"
  • Category 1 free floating hitch
  • Gauge wheel: 3" wide x 8" tall (standard duty)
  • Gearbox Ratio: 1:2.83 with cast iron housing
  • Blade Speed: 71 m/s; 2,223 RPM
  • Rear discharge width: 42 inches
  • PTO driveline shaft included; wider mower
  • For Axle Bolt use ASC # 69637
  • Use ASC #68196 replacement blades
  • Use a pair of ASC #68197 V-belts
  • Use ASC #83778 as replacement wheel
  • Replacement wheel fork, ASC #69627 if unavailable, use 21023 B74 Belt
  • Replacement wheel spacer, ASC #69622
  • For replacement spindle assembly use ASC # 78582
  • Replacement PTO shaft use ASC # 54718

Product Downloads
Featured Review
This shopper rated the product 5 out of 5 stars
Great mower

I bought this 6ft mower from Agri Supply in Greenville, NC. It was fully assembled, but the gearbox was a bit low on oil. It had some grease on the fittings but I greased everything again to make sure. I disassembled the PTO shaft and greased the fittings on each U-joint, both sections of the slip shaft, and the plastic bushings at each end of the yellow PTO cover. One of the wheels seems to have rough bearings and doesn't spin freely. Some grease helped it a bit, and I'll see how it feels after a few uses. The 6ft mower does not have a anti scalping roller in the center, but badly needs one if your yard is not flat. I scalped a section the grass in front of the house where it starts to slope to the ditch. I purchased a roller for the 7ft mower (part# 020052 - Item# 102408 - Front roller assembly for 7ft mower) and installed it. Check your PTO shaft clearance when you raise the mower all the way up if you install this roller. Mine is against the roller at full lift. I use the mower with a John Deere 855 compact tractor (24 engine hp, 19 PTO hp) and it works great. I was a bit concerned that it would bog down the engine since it has a hydro-static transmission and electric PTO clutch. You can't gradually engage the PTO like with a clutch, the electric operated clutch is either on or off. But it doesn't bother the engine at all, just rev it up and engage the PTO. The mower is actually pretty quiet while in operation, and does a good job of mowing. I purchased mulching blades for it, but the mulching kit with the covers was not available through Agri Supply. If the grass gets too high, the mower will leave clumps of grass behind. I probably need another counter weight or two in the front. I have 75 lbs right now, and it's not hard to get the front wheels off the ground if I start too quickly. I appreciate Agri Supply's customer service, I called before making the 1.5 hour drive to get the mower to make sure everything was in stock and they had it ready when I arrived. They also had the part number and website where I could order the mulching kit if I wanted it. I also like that the manual for the mower is on the same web page as the mower. I can print it out since the one that came in the storage tube attached to the mower was soaked. — Joe from NC

Read More Reviews
May We Suggest
Product Review Summary
Based on 24 reviews
The average rating for this product is 5 out of 5 stars
Overall Rating: 5.0/5.0
Customer Reviews
June 16, 2023
Great mower
This shopper rated the product 5 out of 5 stars

I bought this 6ft mower from Agri Supply in Greenville, NC. It was fully assembled, but the gearbox was a bit low on oil. It had some grease on the fittings but I greased everything again to make sure. I disassembled the PTO shaft and greased the fittings on each U-joint, both sections of the slip shaft, and the plastic bushings at each end of the yellow PTO cover. One of the wheels seems to have rough bearings and doesn't spin freely. Some grease helped it a bit, and I'll see how it feels after a few uses. The 6ft mower does not have a anti scalping roller in the center, but badly needs one if your yard is not flat. I scalped a section the grass in front of the house where it starts to slope to the ditch. I purchased a roller for the 7ft mower (part# 020052 - Item# 102408 - Front roller assembly for 7ft mower) and installed it. Check your PTO shaft clearance when you raise the mower all the way up if you install this roller. Mine is against the roller at full lift. I use the mower with a John Deere 855 compact tractor (24 engine hp, 19 PTO hp) and it works great. I was a bit concerned that it would bog down the engine since it has a hydro-static transmission and electric PTO clutch. You can't gradually engage the PTO like with a clutch, the electric operated clutch is either on or off. But it doesn't bother the engine at all, just rev it up and engage the PTO. The mower is actually pretty quiet while in operation, and does a good job of mowing. I purchased mulching blades for it, but the mulching kit with the covers was not available through Agri Supply. If the grass gets too high, the mower will leave clumps of grass behind. I probably need another counter weight or two in the front. I have 75 lbs right now, and it's not hard to get the front wheels off the ground if I start too quickly. I appreciate Agri Supply's customer service, I called before making the 1.5 hour drive to get the mower to make sure everything was in stock and they had it ready when I arrived. They also had the part number and website where I could order the mulching kit if I wanted it. I also like that the manual for the mower is on the same web page as the mower. I can print it out since the one that came in the storage tube attached to the mower was soaked.

Joe from NC
June 07, 2023
Excellent mower
This shopper rated the product 5 out of 5 stars

I have been using this mower since new in 2016. Excellent quality. I am rough on it. The Estate mower has been very strong against hits. All is well

mxpilot from TN
June 12, 2020
Good value
This shopper rated the product 5 out of 5 stars

Purchased this mower to replace a failing belly mower on a New Holland 1620. Shipping was quicker than expected and the unit arrived in good condition. It came greased and with oil in the gearbox ready to mow. Only issue was missing spacers and pin on one wheel, most likely during shipping. Called customer service the next day and replacements are on the way. The main reason I chose AGRI Supply was because of the positive customer service reviews, and based on my experiences from the order, delivery and my call to replace the parts, I made the right choice.

Did you buy this product from Agri Supply?: Yes
Tom Golden from NY
July 31, 2019
GREAT MOWER
This shopper rated the product 5 out of 5 stars

Purchased the mower deck 2 weeks ago and it was delivered on time, undamaged with all parts delivered as promised. Oil was already serviced in the gearbox, grease fittings filled, etc., and ready to assemble drive shaft to tractor and mower gearbox. Had to make a 4-inch cut on the drive shaft because they give you extra length to accommodate all types of tractors. No problem. Adjusted the height of the wheels with supplied spacers, but replaced the existing pins with heavy duty cotter pin types so they wouldn't come off. Otherwise, perfect cutting machine, nice finishing job on lawn. I cut 4 acres in about two hours. Runs smoothly and not a lot of noise. Good price for such a heavy duty, quality mower. I noticed that replacement parts are reasonably priced. Recommend this as a replacement mower which is what I did for a 5 ft. Woods mower. Customer service representative Susan was terrific on the phone answering any questions.

Did you buy this product from Agri Supply?: Yes
Robert S. from OH
August 14, 2017
Solid unit well built and assembled
This shopper rated the product 5 out of 5 stars

I received my 6' mower.It was assembled and oiled and greased.All I had to do was hook up the pto shaft and mow.The steel is a heavy gauge and the paint is ok.It runs smooth and quiet.The casters have grease fittings as well.Its a great mower for the price same construction as the ones that cost twice as much.

Did you buy this product from Agri Supply?: Yes
Doug P from CT