Grizzly® 7' Rear Discharge Estate Mower
Specifications:
- Model Number: SGM-84
- Cutting width: 7'
- Weight: 661 lbs.
- Input RPM: 540
- Hitch: Category 1
- Tractor HP: 20-50
- Cutting height: 3/4" - 4 1/3"
- Cutting height is adjusted with spacers on the wheel forks
- Deck Thickness: 3/16"
- Number of Blades: 3 ASC # 124891
- Blade overlap: 1"
- Blade tip speed: 15,275 feet per minute
- Front anti-scalping roller standard
- Utilizes 2 belts
- Three-point hitch can be configured to be free floating or fixed
- Blade spindles are greaseable
- Wheels: 10"x3.25" solid rubber
- For replacement belts, use qty 1 of 126961 - 92-1/8 inch Belt (Set of 2)
- For replacement PTO shafts use ASC #89798 or ASC #54718A
- For Top Hitch Support LH Use ASC # 133663
- For Top Hitch Support RH Use ASC # 133673
- For Top Hitch Arm use ASC # 133664
- For Front Roller Wheel use ASC # 133668
- For Front Roller Bracket use ASC # 133669
- For Front Roller Rod Axle use ASC # 133670
- For Gearbox Assembly Gasket #18 use ASC # 134320
- For Square Neck Bolt M10 x 1.5 x 30 use ASC # 133671
- For Nylock Nut use ASC # 133672
- For replacement wheel fork, use ASC# 124901
- For models made before 4-27-24, use this breakdown
Shipping & Returns
Shipping & Return PolicyI PURCHASED THE 7" GRIZZLY FINISH MOWER AND I AM VERY PLEASED WITH THE WAY IT CUTS AND THE WAY IT SPREADS THE CLIPPINGS WITH NO CLUMPING OR GRASS LINES BETWEEN THE BLADE OVERLAP. THE VERY FIRST USE OF THE MOWER PRESENTED BE WITH WHEEL PROBLEMS. THE AREA THAT I AM CUTTING IS NOT PERFECTLY FLAT AND I DO MOW WITH THE TRACTOR AND MOWER IN THE "FLOAT" POSITION. MY FIRST CUT WAS AT 3" AND I HAD TO RAISE THE MOWER SUBSTANTIALLY WITH THE AVAILABLE SPACERS, THIS PUT THE YOKE SHAFTS AT QUITE A DISTANCE FROM THE MOUNTS AND TWO OF THE SHAFTS HAVE ALREADY BENT TO THE POINT THAT THE WHEELS WOULD NOT ROTATE WITHOUT HITTING THE SIDES OF THE MOWER DECK; ONE IN FRONT AND ONE IN THE BACK. I WAS ABLE TO REMOVE THE YOKE IN FRONT AND HEAT THE SHAFT TO BEND IT BACK TO ALMOST STRAIGHT, AND THE HEIGHT SPACERS STILL SLID ONTO THE SHAFT. IN MY OPINION, THE 1" DIAMETER YOKE SHAFTS SHOULD BE LARGER AND THE BUSHINGS SHOULD BE BRASS NOT PLASTIC. WITH THE MOWER RAISED TO MAXIMUM CUTTING HEIGHTH THE YOKES ARE UNDER A LOT OF STRESS ESPECIALLY IF THE WHEEL FALLS INTO A LOW SPOT IN AN UNEVEN MOWING TERRAIN. OVERALL, I AM PLEASE WITH THE MOWER OTHER THAN THE WHEEL ISSUE. IT WAS EASY TO CONNECT TO MY TRACTOR AND GAVE MY MOWED AREA A NICE GROOMED CUT AS IF I WERE USING A LAWN MOWER. I DO RECOMMEND AGRI-SUPPLY, I HAVE USED THEM FREQUENTLY FOR IMPLEMENT AND TRACTOR PARTS, THEY ARE FRIENDLY, COURTIOUS, AND READY TO HELP IN ANY WAY TO FIND THE PARTS OR EQUIPMENT YOU NEED. — TOMMY from TX
Read More Reviews
